Instruction manual

16 IMR01Y06-E6
5. SETTING
Do not separate the mainframe from the terminal base with the power turned on.
If so, instrument failure may result.
5.1 Station Number Setting
Set the station number of CC-Link. For this setting, use a small blade screwdriver.
When set to any value out of the setting range, the COM-JC becomes the FAIL state.
Setting range:
1 to 61 (4 stations occupied 1 time,
4 stations occupied 2 times)
1 to 64 (1 station occupied 1 time)
Factory set value: 0
Station number
setting switch
High-order digit
setting
(Set value × 10)
Lo
w
-order digit
setting
(Set value × 1)
z To prevent electric shock or instrument failure, always turn off the power
before setting the switch.
z To prevent electric shock or instrument failure, never touch any section other
than those instructed in this manual.
WARNING
!
CAUTION