Specifications

Temperature Controller Driver
GP-Pro EX Device/PLC Connection Manual
182
BE ST Startup tuning (ST)
BF KI ST proportional band adjusting factor
C0 KJ ST integral time adjusting factor
C1 KK ST derivative time adjusting factor
C2 SU ST start condition
C3 Y7 Automatic temperature rise group
C4 Y8 Automatic temperature rise learning
C5 RT Automatic temperature rise dead time
C6 R2 Automatic temperature rise gradient data
C7 GQ RUN/STOP group
C8 HU Setting change rate limiter unit time
C9 RU Soak time unit
CA SH Setting limiter (high)
CB SL Setting limiter (low)
CC TS PV transfer function
CD DU PV flashing display at input error
• Setting "Use system data area" to GP-Pro EX system area result in improper
operation. Do not set "Use system data area."
• System area setting that can be used for the temperature controller is reading area size only. Please
refer to the GP-Pro EX Reference Manual for system data area.
Cf. GP-Pro EX Reference Manual "Appendix 1.4 LS Area (Direct Access Method)"
• Please refer to the precautions on manual notation for icons in the table.
)"Manual Symbols and Terminology"
• Even if non-existing address is used, there are cases when read error is not indicated. In this case,
zero (0) is kept for read out data. On the other hand, writing error is indicated.
Address Identifier Description