Specifications

Temperature Controller Driver
GP-Pro EX Device/PLC Connection Manual
187
BF HU Setting change rate limiter unit time
C0 RU Soak time unit
C1 SH Setting limiter (high) of input 1
C2 SL Setting limiter (low) of input 1
C3 ST Setting limiter (high) of input 2
C4 SU Setting limiter (low) of input 2
C5 VR ROM version
C6 UT Integrated operating time
C7 Hp Holding peak value ambient temperature
C8 HM Power feed forward input value
C9 VG Feedback resistance (FBR) input assignment
CA PZ Power feed forward gain of input 1
CB PW Power feed forward gain of input 2
CC ND Heater break alarm 1 (HBA1) type
CD DH Number of heater break alarm 1 (HBA1) delay times
CE NG Heater break alarm 2 (HBA2) type
CF DF Number of heater break alarm 2 (HBA2) delay times
D0 LY Alarm (ALM) lamp lighting condition 1
D1 LZ Alarm (ALM) lamp lighting condition 2
D2 HT Not used
D3 FT Not used
D4 OG Not used
D5 LI Not used
D6 OR Not used
D7 TS Not used
D8 US Not used
D9 RH Not used
DA RL Not used
DB RP Not used
DC JI Not used
DD JJ Not used
DE OI Not used
DF OJ Not used
E0 QA Not used
E1 OT Not used
E2 OU Not used
E3 MY Not used
E4 NY Not used
E5 MZ Not used
E6 NZ Not used
• Setting "Use system data area" to GP-Pro EX system area result in improper
operation. Do not set "Use system data area."
• System area setting that can be used for the temperature controller is reading area size only. Please
refer to the GP-Pro EX Reference Manual for system data area.
Cf. GP-Pro EX Reference Manual "Appendix 1.4 LS Area (Direct Access Method)"
• Please refer to the precautions on manual notation for icons in the table.
)"Manual Symbols and Terminology"
• Even if non-existing address is used, there are cases when read error is not indicated. In this case,
zero (0) is kept for read out data. On the other hand, writing error is indicated.
Address Identifier Description