Specifications

Temperature Controller Driver
GP-Pro EX Device/PLC Connection Manual
198
6.7 SA Series
This address can be specified as system data area.
<Communication identifier list>
Device Bit Address Word Address
32
bits
Notes
Communication identifier 0000.0-001E.F 0000-001E
*1 *2
*1 There are cases for which writing is not available depending on the device address. Check the
identifying attributes of the external device’s manual before use.
*2 When bit is written, the indicator reads the corresponding word address of external device, assign
a bit to the read word address, and return to the external device. There are cases when correct data
cannot be written if the word address is written using a ladder program, while the indicator reads
data of the external device and sends it back.
Address Identifier Description
00 M1 Measured value(PV)
01 B1 Burnout
02 AA Alarm 1 status
03 AB Alarm 2 status
04 O1 Heat-side manipulated output value
05 O2 Cool-side manipulated output value
06 ER Error code
07 SR RUN/STOP function
08 G1 Autotuning
09 G2 Self-tuning
0A S1 Set value (SV)
0B A1 Alarm 1 set value
0C A2 Alarm 2 set value
0D A5 Control loop break alarm
0E A6 Control loop break alarm deadband
0F P1 Heat-side proportional band (P)
10 I1 Integral time (I)
11 D1 Derivative time (D)
12 W1 Anti-reset windup
13 T0 Heat-side proportioning cycle time
14 P2 Cool-side proportional band
15 V1 Overlap/deadband
16 T1 Cool-side proportioning cycle time
17 PB PV bias
18 F1 Digital filter
19 LK Set data lock function
1A EB EEPROM storage mode
1B EM EEPROM storage status
1C LA Analog output specification selection
1D HV Analog output scale high
1E HW Analog output scale low