Specifications

Temperature Controller Driver
GP-Pro EX Device/PLC Connection Manual
202
33 XO AO function selection
34 OY AO corresponding channel setting
35 CV AO zooming high limit
36 CW AO zooming low limit
37 JK AO zero point correction
38 JL AO full scale correction
39 L1 DI module input status (DI-A module)
3A C2 CC-Link selecting flag
3B Q3 Event DO status (DO-C module)
3C Q4 Event DO manual output value (DO-C module)
3D A7 Event DO extension alarm set value
3E KH Cascade monitor
3F KF Cascade ON/OFF
40 KG Cascade gain
41 KI Cascade bias
42 M7 TI measured value
43 AF TI alarm 1 status
44 AG TI alarm 2 status
45 B2 TI burnout status
46 A8 TI alarm 1 set value
47 A9 TI alarm 2 set value
48 PC TI PV bias
49 EJ TI operation mode transfer
4A L3 PCP module DI status
4B L4 Event DI contact input monitor (DI-B module)
4C L5 Event DI logic input monitor
4D Q5 Event DI logic output monitor
4E AH CT module heater break alarm status
4F AJ Comprehensive alarm status
50 M8 Positioning monitor
51 V3 Positioning output neutral zone
52 TJ Motor time
53 OS Integrated output limite
54 OO Manual positioning output value
55 C1 Local/Computer transfer
• Setting "Use system data area" to GP-Pro EX system area result in improper
operation. Do not set "Use system data area."
• System area setting that can be used for the temperature controller is reading area size only. Please
refer to the GP-Pro EX Reference Manual for system data area.
Cf. GP-Pro EX Reference Manual "Appendix 1.4 LS Area (Direct Access Method)"
• Please refer to the precautions on manual notation for icons in the table.
)"Manual Symbols and Terminology"
• Even if non-existing address is used, there are cases when read error is not indicated. In this case,
zero (0) is kept for read out data. On the other hand, writing error is indicated.
Address Identifier Description