Specifications

Temperature Controller Driver
GP-Pro EX Device/PLC Connection Manual
206
6.10 REX-F9000 Series
This address can be specified as system data area.
<Communication identifier list>
Device Bit Address Word Address
32
bits
Notes
Communication identifier 0000.00-002F.1F 0000-002F
*1 *2 *3
*1 There are cases for which writing is not available depending on the device address. Check the
identifying attributes of the external device’s manual before use.
*2 When bit is written, the indicator reads the corresponding word address of external device, assign
a bit to the read word address, and return to the external device. There are cases when correct data
cannot be written if the word address is written using a ladder program, while the indicator reads
data of the external device and sends it back.
*3 32-bit device
Address Identifier Description
00 M1 Measured-value(PV)
01 AA First alarm output
02 AB Second alarm output
03 O1 Manipulated output value(MV)
04 B1 Burnout
05 ER Error code
06 G1 PID/AT transferPID control/auto-tuning transfer
07 J1 Auto/Manual transfer
08 SR Operation execution (RUN)/STOP transfer
09 S1 Set value (SV)
0A A1 First alarm setting
0B A2 Second alarm setting
0C P1 Proportional band
0D I1 Integral time
0E D1 Derivative time
0F CA Control response designation parameter
10 PB PV bias
11 PC Sensor bias
12 F1 digital filter
13 OH Output limit (High limit)
14 OL Output limit (Low limit)
15 GB AT bias
16 HA First alarm differential gap
17 TD First alarm timer setting
18 HB Second alarm differential gap
19 TG Second alarm timer setting
1A LA Analog output Specification selection
1B HV Analog output Scale high limit
1C HW Analog output Scale low limit
1D DA Bar-graph display selection
1E XI Input type selection
1F XU Decimal-point position selection
20 JT Power supply frequency
21 SH Setting limit (High limit)