Specifications

Temperature Controller Driver
GP-Pro EX Device/PLC Connection Manual
211
6.12 REX-D Series
This address can be specified as system data area.
<Communication identifier list>
Device Bit Address Word Address
32
bits
Notes
Communication identifier 0000.0-003E.F 0000-003E
*1 *2
*1 There are cases for which writing is not available depending on the device address. Check the
identifying attributes of the external device’s manual before use.
*2 When bit is written, the indicator reads the corresponding word address of external device, assign
a bit to the read word address, and return to the external device. There are cases when correct data
cannot be written if the word address is written using a ladder program, while the indicator reads
data of the external device and sends it back.
Address Identifier Description
00 M1 Measured-value(PV)
01 M2 First current transformer input value(CT1)
02 M3 Second current transformer input value(CT2)
03 AA First alarm output
04 AB Second alarm output
05 AC Heater break alarm output 1
06 AD Heater break alarm output 2
07 AE Control loop break alarm
08 B1 Burnout
09 O1 Manipulated output 1(Heating-side)
0A O2 Manipulated output 2(Cooling-side)
0B MS Set-value(SV)monitoring
0C ER Error data
0D J1 AUTO/MAN transfer
0E SR RUN/STOP transter
0F G1 PID/Auto-tuning transfer
10 S1 Set-value(SV1)
11 ON Manipulated output value(MV)
12 S2 Step set-value(SV2)
13 A1 First alarm setting
14 A2 Second alarm setting
15 A3 First heater break alarm setting
16 A4 Second heater break alarm setting
17 PB PV bias
18 HH SV change rate limit
19 XA First alarm action selection
1A HA First alarm differential gap
1B TD First alarm timer setting
1C A5 Control loop break alarm setting
1D V3 LBA deadband
1E XB Second alarm action selection
1F HB Second alarm differential gap setting
20 TG Second alarm timer setting
21 TH HBA delay timer
22 P1 Proportional band(Heating-side)