Specifications

Temperature Controller Driver
GP-Pro EX Device/PLC Connection Manual
212
23 I1 Integral time
24 D1 Derivative time
25 W1 Anti-reset windup(ARW)
26 P2 Cooling-side proportional band
27 V1 Overlap/deadband
28 MH ON/OFF action differential gap
29 MR Manual reset
2A XP Fazzy
2B T0 Proportioning cycle(OUT1)
2C OH Output limit(High-limit)
2D OL Output limit(Low-limit)
2E XE Direct/reverse action selection
2F T1 Proportioning cycle(OUT2)
30 OI Output limit(high-limit)(OUT2)
31 LA Analog output specification selection
32 HV High limit analog output range
33 HW Low limit analog output range
34 XI Input type selection
35 XV Scaling high-limit
36 XW Scaling low-limit
37 XU Decimal-point position selection
38 PQ AUTO/MAN function selection
39 DH Control RUN/STOP display selection
3A XR Current transformer type selection
3B XQ Air cooling/water cooling selection
3C GH Auto-tuning(AT)differential gap
3D WH Action selection at input abnormality
3E XO Universal output selection
• Setting "Use system data area" to GP-Pro EX system area result in improper
operation. Do not set "Use system data area."
• System area setting that can be used for the temperature controller is reading area size only. Please
refer to the GP-Pro EX Reference Manual for system data area.
Cf. GP-Pro EX Reference Manual "Appendix 1.4 LS Area (Direct Access Method)"
• Please refer to the precautions on manual notation for icons in the table.
)"Manual Symbols and Terminology"
• Even if non-existing address is used, there are cases when read error is not indicated. In this case,
zero (0) is kept for read out data. On the other hand, writing error is indicated.
Address Identifier Description