Specifications

Temperature Controller Driver
GP-Pro EX Device/PLC Connection Manual
213
6.13 REX-G9 Series
This address can be specified as system data area.
<Communication identifier list>
Device Bit Address Word Address
32
bits
Notes
Communication identifier 0000.00-005E.1F 0000-005E
*1 *2 *3
*1 There are cases for which writing is not available depending on the device address. Check the
identifying attributes of the external device’s manual before use.
*2 When bit is written, the indicator reads the corresponding word address of external device, assign
a bit to the read word address, and return to the external device. There are cases when correct data
cannot be written if the word address is written using a ladder program, while the indicator reads
data of the external device and sends it back.
*3 32-bit device
Address Identifier Description
00 M1 Measured-value (PV) input
01 AA First alarm output
02 AB Second alarm output
03 AC Third alarm output
04 O1 Manipulated output1
05 B1 Burnout
06 B2 Feedback resistance (FBR) input burnout
07 S2 Remote setting value
08 M2 Feedback display
09 MS Set-value (SV) monitoring
0A J1 Auto/Manual transfer
0B C1 Remote/Local transfer
0C E1 Local/external memory area transfer
0D ZA Control area No. transfer
0E G1 PID control/auto-tuning transfer
0F RA Computer mode/local mode identification
10 SR Operation execution (RUN)/STOP transfer
11 ON Manipulated output value
12 S1 Set-value (SV)
13 A1 First alarm setting
14 A2 Second alarm setting
15 A3 Third alarm setting
16 P1 Proportional band
17 I1 Integral time
18 D1 Derivative time
19 CA Control response designation parameter
1A PB PV bias
1B F1 PV digital filter
1C VA PV Moving average
1D DP PV low input cut-off
1E HH Setting change rate limiter (up)
1F HL Setting change rate limiter (down)
20 RR RS ratio
21 RB RS bias