Specifications

Temperature Controller Driver
GP-Pro EX Device/PLC Connection Manual
214
22 F2 RS digital filter
23 VB RS Moving average
24 OH Output limit (High limit)
25 OL Output limit (Low limit)
26 PH Increase in output change rate limit
27 PL Decrease in output change rate limit
28 IV Upper ON/OFF action (A) differential gap
29 IW Lower ON/OFF action (A) differential gap
2A DG Derivative gain
2B OE Manual output at abnormality
2C GB AT bias
2D G2 AT cycles
2E HA Alarm 1 hysteresis
2F HB Alarm 2 hysteresis
30 HC Alarm 3 hysteresis
31 LA Analog output 1 Specification selection
32 HV Analog output 1 Scale high limit
33 HW Analog output 1 Scale low limit
34 LB Analog output 2 Specification selection
35 CV Analog output 2 Scale high limit
36 CW Analog output 2 Scale low limit
37 V2 Neutral zone
38 VH Open/close hysteresis
39 SY Action selection at feedback resistance (FBR) input break
3A TL Display update cycle
3B DA Deflection bar graph(display/non-display)
3C DB RS bar graph(display/non-display)
3D DC PV bar graph(display/non-display)
3E DE Range of display in deflection bar graph
3F XI PV input type selection
40 AV Input abnormality determination point (High limit)
41 AW Input abnormality determination point (Low limit)
42 WH Action selection at input abnormality (High limit)
43 WL Action selection at input abnormality (Low limit)
44 XV Input programmable range (High limit)
45 XW Input programmable range (Low limit)
46 PU PV input unit
47 XU Decimal-point position selection
48 XH Square root extraction selection
49 SH Setting limit (High limit)
4A SL Setting limit (Low limit)
4B XR RS input type selection
4C XL SV tracking selection
4D T0 Output cycles
4E XE Direct/reverse action selection
4F DT Derivative cycle
50 XN Hot/Cold start selection
51 XA First alarm Action selection
52 NA First alarm Energized/de-energized selection
53 OA First alarm Action selection at input abnormality
54 WA First alarm Hold action selection
55 XB Second alarm Action selection
Address Identifier Description