Specifications

Temperature Controller Driver
GP-Pro EX Device/PLC Connection Manual
218
56 V4 Deadband/Overlap 4 / Control motor neutral zone 4
57 XP Fuzzy function 1
58 FW Fuzzy function 2
59 FX Fuzzy function 3
5A FY Fuzzy function 4
5B TC Output cycle 1 / Control motor time
5C T0 Output cycle 2
5D OH Output limit(High limit) / Integrated output limit
5E OL Output limit(Low limit)
5F XE Direct/reverse action selection
60 KB OUT2 action selection
61 A3 OUT2 set value
62 XC OUT3 action selection
63 A4 OUT3 set value
64 XD OUT4 action selection
65 A5 OUT4 set value
66 LA Analog output selection
67 HV Analog output scaling high limit
68 HW Analog output scaling low limit
69 XI Input type selection
6A XV Scale high limit
6B XW Scale low limit
6C XU Decimal point position
6D SS SV at program start
6E X1 Control state at program end
6F XN Control output value during reset / Control state selection during reset
70 XK Control input pattern entry method
71 XQ Water cooling/air cooling selection at heat/cool control
72 PD Start mode selection
73 GH Autotuning(AT) differential gap
74 JT Power frequency
75 B2 Action selection at burnout occurrence
76 WH Action selection for abnormal PV input
77 XH Selection of Use/Non-use of square root extraction function
78 PU Setting time unit selection
• Setting "Use system data area" to GP-Pro EX system area result in improper
operation. Do not set "Use system data area."
• System area setting that can be used for the temperature controller is reading area size only. Please
refer to the GP-Pro EX Reference Manual for system data area.
Cf. GP-Pro EX Reference Manual "Appendix 1.4 LS Area (Direct Access Method)"
• Please refer to the precautions on manual notation for icons in the table.
)"Manual Symbols and Terminology"
• Even if non-existing address is used, there are cases when read error is not indicated. In this case,
zero (0) is kept for read out data. On the other hand, writing error is indicated.
Address Identifier Description