Specifications

Temperature Controller Driver
GP-Pro EX Device/PLC Connection Manual
219
6.15 REX-P250 Series
This address can be specified as system data area.
<Communication identifier list>
Device Bit Address Word Address
32
bits
Notes
Communication identifier 0000.0-0027.F 0000-0027
*1 *2
*1 There are cases for which writing is not available depending on the device address. Check the
identifying attributes of the external device’s manual before use.
*2 When bit is written, the indicator reads the corresponding word address of external device, assign
a bit to the read word address, and return to the external device. There are cases when correct data
cannot be written if the word address is written using a ladder program, while the indicator reads
data of the external device and sends it back.
Address Identifier Description
00 M1 Measured-value(PV)
01 S1 Set-value(SV)during operation
02 ON Manipulated-value(MV)or Manual control output set-value
03 TR Segment remaining time
04 RT The number of program execution times
05 M2 Opening feedback input value or Current transformer input value
06 AA Alarm 1 output
07 AB Alarm 2 output
08 B1 Burnout
09 HO Hold status
0A EN End status
0B WT Wait status
0C T1 Time signal No.1 status
0D T2 Time signal No.2 status
0E T3 Time signal No.3 status
0F T4 Time signal No.4 status
10 XM Operation mode
11 PS Execution pattern
12 SN Execution segment
13 RA COMP/LOC identification
14 G1 AT/PID identification
15 TT AT learning function
16 SK Step function
17 S2 Set-value(SV)
18 PP PID memory NO.
19 AP Alarm memory NO.
1A PQ PID memory NO.
1B AQ Alarm memory NO.
1C PB PV bias
1D HA Alarm 1 hysteresis band
1E HB Alarm 2 hysteresis band
1F TC Proportional cycle setting
20 F1 Digital filter
21 XN Start mode selection
22 SS Set-value(SV)selection at start[Program control]