Specifications

Temperature Controller Driver
GP-Pro EX Device/PLC Connection Manual
222
23 NC Third alarm Energized/De-energized
24 HC Third alarm differential gap
25 TH Third alarm timer setting selection
26 XD Fourth alarm action selection
27 QD Fourth alarm interlock
28 ND Fourth alarm Energized/De-energized
29 HD Fourth alarm differential gap
2A TI Fourth alarm timer setting selection
2B XE Fifth alarm action selection
2C QE Fifth alarm interlock
2D NE Fifth alarm Energized/De-energized
2E HE Fifth alarm differential gap
2F TJ Fifth alarm timer setting selection
30 XF Sixth alarm action selection
31 QF Sixth alarm interlock
32 NF Sixth alarm Energized/De-energized
33 HF Sixth alarm differential gap
34 TK Sixth alarm timer setting selection
35 HV Analog output high-limit set-value
36 HW Analog output low-limit set-value
37 XI Input type selection
38 XV Scaling high-limit setting
39 XW Scaling low-limit setting
3A XU Decimal point position selection
3B TS Time unit selection setting
• Setting "Use system data area" to GP-Pro EX system area result in improper
operation. Do not set "Use system data area."
• System area setting that can be used for the temperature controller is reading area size only. Please
refer to the GP-Pro EX Reference Manual for system data area.
Cf. GP-Pro EX Reference Manual "Appendix 1.4 LS Area (Direct Access Method)"
• Please refer to the precautions on manual notation for icons in the table.
)"Manual Symbols and Terminology"
• Even if non-existing address is used, there are cases when read error is not indicated. In this case,
zero (0) is kept for read out data. On the other hand, writing error is indicated.
Address Identifier Description