Specifications

Temperature Controller Driver
GP-Pro EX Device/PLC Connection Manual
223
6.17 REX-PG Series
This address can be specified as system data area.
<Communication identifier list>
Device Bit Address Word Address
32
bits
Notes
Communication identifier 0000.0-0021.F 0000-0021
*1 *2
*1 There are cases for which writing is not available depending on the device address. Check the
identifying attributes of the external device’s manual before use.
*2 When bit is written, the indicator reads the corresponding word address of external device, assign
a bit to the read word address, and return to the external device. There are cases when correct data
cannot be written if the word address is written using a ladder program, while the indicator reads
data of the external device and sends it back.
Address Identifier Description
00 M1 Measured-value (PV)
01 AA Alarm 1 monitor
02 AB Alarm 2 monitor
03 B1 Burnout
04 ER Error data
05 HP Peak hold monitor
06 HQ Bottom hold monitor
07 AZ Auto 0
08 HR Hold reset
09 IR Alarm interlock release
0A A1 First alarm setting
0B A2 Second alarm setting
0C IB Operation selection when input break
0D TL Display time setting
0E XA First alarm Action selection
0F QA First alarm interlock function
10 NA First alarm Energized/de-energized selection
11 HA First alarm differential gap
12 TD First alarm timer setting
13 XB Second alarm Action selection
14 QB Second alarm interlock function
15 NB Second alarm Energized/de-energized selection
16 HB Second alarm differential gap
17 TG Second alarm timer setting
18 HW Low limit analog output range
19 HV High limit analog output range
1A TO Analog output time setting
1B XI Input type selection
1C GA Gain setting
1D PU Pressure unit setting
1E XU Decimal-point position selection
1F XW Pressure display low limit setting
20 XV Pressure display high limit setting
21 LI Linearizing type selection