Specifications

Temperature Controller Driver
GP-Pro EX Device/PLC Connection Manual
225
6.18 AE500 Series
This address can be specified as system data area.
<Communication identifier list>
Device Bit Address Word Address
32
bits
Notes
Communication identifier 0000.0-0012.F 0000-0012
*1 *2
*1 There are cases for which writing is not available depending on the device address. Check the
identifying attributes of the external device’s manual before use.
*2 When bit is written, the indicator reads the corresponding word address of external device, assign
a bit to the read word address, and return to the external device. There are cases when correct data
cannot be written if the word address is written using a ladder program, while the indicator reads
data of the external device and sends it back.
Address Identifier Description
00 M1 Measured value (PV)
01 AA Alarm 1 monitor
02 AB Alarm 2 monitor
03 AC Alarm 3 monitor
04 AD Alarm 4 monitor
05 B1 Burnout
06 ER Error code
07 A1 Alarm 1 setting
08 A2 Alarm 2 setting
09 A3 Alarm 3 setting
0A A4 Alarm 4 setting
0B HA Alarm 1 differential gap setting
0C HB Alarm 2 differential gap setting
0D HC Alarm 3 differential gap setting
0E HD Alarm 4 differential gap setting
0F PB PV bias
10 HV Analog output scale high
11 HW Analog output scale low
12 LK Set data lock function
• Setting "Use system data area" to GP-Pro EX system area result in improper
operation. Do not set "Use system data area."
• System area setting that can be used for the temperature controller is reading area size only. Please
refer to the GP-Pro EX Reference Manual for system data area.
Cf. GP-Pro EX Reference Manual "Appendix 1.4 LS Area (Direct Access Method)"
• Please refer to the precautions on manual notation for icons in the table.
)"Manual Symbols and Terminology"
• Even if non-existing address is used, there are cases when read error is not indicated. In this case,
zero (0) is kept for read out data. On the other hand, writing error is indicated.