Specifications

Temperature Controller Driver
GP-Pro EX Device/PLC Connection Manual
232
Address Identifier
Description
Address Identifier
Description
C2 SL Setting limiter (low) C9 DY
Output distribution master channel mod-
ule address
C3 TS
PV transfer function CA DZ
Output distribution master channel selec-
tion
C4 EA
Operation mode assignment 1
(Logic output selection function)
Logic output 1 to 4
CB RL Address of interacting modules
C5 EB
Operation mode assignment 2
(Logic output selection function)
Logic output 5 to 8
CC RM Channel selection of interacting modules
C6 KM SV select function CD RN Selection switch of interacting modules
C7 MC
Remote SV function master channel
module address
CE X1 Control RUN/STOP holding setting
C8 MN
Remote SV function
master channel selection
CF ZX Interval time
• Setting "Use system data area" to GP-Pro EX system area result in improper
operation. Do not set "Use system data area."
• System area setting that can be used for the temperature controller is reading area size only.
Please refer to the GP-Pro EX Reference Manual for system data area.
Cf. GP-Pro EX Reference Manual "Appendix 1.4 LS Area (Direct Access Method)"
• Please refer to the precautions on manual notation for icons in the table.
)"Manual Symbols and Terminology"
• Even if non-existing address is used, there are cases when read error is not indicated. In this
case, zero (0) is kept for read out data. On the other hand, writing error is indicated.