Specifications

Temperature Controller Driver
GP-Pro EX Device/PLC Connection Manual
234
<Communication identifier list>
Address Identifier
Description
Address Identifier
Description
00 VR ROM version 10 VJ
DO minimum ON/OFF time of
proportioning cycle
01 VR ROM version 11 H2 DI function assignment
02 L1 Digital input (DI) state 1 12 E1 Memory area setting signal
03 L6 Digital input (DI) state 2 13 LQ
DO signal assignment module address 1
04 Q2 Digital output (DO) state 1 14 LR DO signal assignment module address 2
05 Q3 Digital output (DO) state 2 15 LT DO output assignment 1 [DO1 to DO4]
06 ER Error code 16 LX DO output assignment 2 [DO5 to DO8]
07 UT Integrated operating time monitor 17 NB DO energized/de-energized
08 EM Backup memory state monitor 18 DD
DO output distribution master channel
module address
09 SR RUN/STOP transfer 19 DJ
DO output distribution master channel
selection
0A Q4
DO manual output 1 1A OJ
DO manipulated output value (MV) at
STOP mode
0B Q5
DO manual output 2 1B D3 DO output limiter (high)
0C DO DO output distribution selection 1C D4 DO output limiter (low)
0D O8 DO output distribution bias 1D X1 Control RUN/STOP holding setting
0E O9 DO output distribution ratio 1E ZX Interval time
0F V0 DO proportional cycle time
• Setting "Use system data area" to GP-Pro EX system area result in improper opera-
tion. Do not set "Use system data area."
• System area setting that can be used for the temperature controller is reading area size only.
Please refer to the GP-Pro EX Reference Manual for system data area.
Cf. GP-Pro EX Reference Manual "Appendix 1.4 LS Area (Direct Access Method)"
• Please refer to the precautions on manual notation for icons in the table.
)"Manual Symbols and Terminology"
• Even if non-existing address is used, there are cases when read error is not indicated. In this
case, zero (0) is kept for read out data. On the other hand, writing error is indicated.