Specifications

Temperature Controller Driver
GP-Pro EX Device/PLC Connection Manual
236
<Communication identifier list>
Address
Identifier
Description Address
Identifier
Description
00 VR ROM version 0F BO Heater overcurrent alarm selection
01 VR ROM version 10 CX
Heater break alarm (HBA) interlock
release
02 M4
Current transformer (CT) input value
monitor
11 CY
Heater overcurrent alarm interlock
release
03 M5 Load factor conversion CT monitor 12 LK
Set lock
04 AF Heater break alarm (HBA) state monitor 13 BV CT type
05 AG Heater overcurrent alarm state monitor 14 XT CT ratio (CT number of winds)
06 ER Error code 15 DI
Number of heater break alarm (HBA)
delay times
07 UT Integrated operating time monitor 16 BW
Automatic setting factor for heater break
alarm (HBA)
08 EM Backup memory state monitor 17 B9
Automatic setting factor for heater over-
current alarm
09 CJ Automatic setting state monitor 18 BP
Determination current value for auto-
matic setting
0A BT
Heater break/Heater overcurrent alarm
automatic setting selection
19 BQ Automatic setting time
0B BU Automatic setting transfer 1A BX
Module address assignments for CT
input
0C A8 Heater break alarm (HBA) set value 1B BY
Module channel assignments for CT
input
0D BZ Heater break alarm (HBA) selection 1C IC Load factor conversion method
0E A6 Heater overcurrent alarm set value 1D ZX Interval time
• Setting "Use system data area" to GP-Pro EX system area result in improper opera-
tion. Do not set "Use system data area."
• System area setting that can be used for the temperature controller is reading area size only.
Please refer to the GP-Pro EX Reference Manual for system data area.
Cf. GP-Pro EX Reference Manual "Appendix 1.4 LS Area (Direct Access Method)"
• Please refer to the precautions on manual notation for icons in the table.
)"Manual Symbols and Terminology"
• Even if non-existing address is used, there are cases when read error is not indicated. In this
case, zero (0) is kept for read out data. On the other hand, writing error is indicated.