Manual
• If you have a winch you can either install it now
or after you have the bumper is installed. Be sure
to install the fair lead bolts before installing the
winch.
• Install Road Armor logo now because you wont be
able to later.
• Install license plate lights and back up sensor in-
serts into Road Armor bumper.
Note : use side cutters and cut a 1/8 off the plastic
clips on the back up sensor inserts to makeup for the
thickness of the 3/16 steel. Make the to cut the same
angle that it originally was from the factory.
Pictures 10
• Measure across the bracket slots and align the bolt
tabs on the bumper to the distance you measured
on the brackets for an easy install.
Pictures 11 - 12
• Mask off the corners of the body to prevent scratch-
es.
• Install bumper using 1/2” hardware and snug up one
bolt per side so you can make adjustments.
• Square the bumper to the body by measuring from
the top face of the bumper to a body line on both
sides of the vehicle. In addition, measure from side
to side.
Picture 13
• Caution - when positioning the bumper, open the
tailgate with caution to make sure the bottom of
the tail gate clears the bumper.
• Once bumper is squared up to the body, tighten the
1/2” hardware.
• Plug in license plate lights and back up sensors.
Note : If you have back up sensors you will need to un-
plug the outside sensors from the wire harness in order
to sh the plugs through the brackets.
5
6
7