Owner manual

Repeat this step for the other side of the bumper.

Hand tighten all hardware to allow for adjustment

at a later step.

• Insert the four other bolt plates into the inner slots

of the brackets fasten with one ½” at washer, ½”

lock washer, and one ½” nut on each bolt in each

bolt plate. Hand tighten all hardware.

Picture 10

• Make nal adjustment to bumper and tighten all

hardware. Once bumper is fully adjusted attach

stainless steel road armor logo to bumper with sup-

plied hardware

Picture 11

STEP 5:

• Once bumper is fully adjusted the plastic liner in

the wheel well needs to be cut back to t inside road

armor bumper. Draw with a crayon or marker where it

needs to be cut. Use a utility knife to cut plastic liner.

NOTE: If you are unsure how much to cut away from liner

cut a small portion and try to t liner behind bumper. If it

will not t trim more off until it ts to your liking. When

you are done the plastic should look like the picture 12.

Repeat for other side of the bumper.