Operation Manual

English English
3 4
the DC 5 V INPUT socket (13) located on the back of the unit.
2. Connect the AC/DC adaptor into a 230V ~ 50Hz AC power
outlet.
Notes:
• Use only the supplied AC/DC adaptor. Using other types of
adaptor may damage the unit.
• Make sure that the AC/DC adaptor matches with your household
voltage before connecting it into the wall outlet.
• Do not touch the AC/DC adaptor with wet hands.
Battery Back-up Power Failure Protection
This radio has a battery back up circuit that will keep the correct
time and alarm settings in the event of a temporary power
interruption.
Install 2 x 1,5-volt battery (type UM4), not included, into the
battery compartment located on the bottom of the unit.
Note:We recommend an alkaline battery for longer usable life.
Change the battery every 9 to 12 months for best result and avoid
possible battery leakage.
If power is temporarily interrupted the display will blink and the
radio will not play. However, the battery back-up circuit will
continue to maintain the clock and alarm settings. When power is
restored the clock will display the correct time and alarm settings,
and no adjustment is necessary.
SETTING THE CORRECT TIME
NOTE: The Clock can be set only if the unit is in Stand-By mode (radio
OFF).
1. Press 2 seconds the SET TIME Button (10) until the display blink.
2. Press the SET HOUR BUTTON / TUNING DOWN (4) button to
advance hour
3. Press the SET MINUTE BUTTON / TUNING UP (3) button to
advance MINUTE until the correct time is displayed.
4. Press the TIME SET Button (11) to complete the setting operation.
SETTING THE WAKE UP TIME
1. Set the alarm time by following this procedure:
2. Press 2 seconds the ALARM 1 / VOL- (6) or ALARM 2 / VOL+ (5)
Button.
3. Press the SET HOUR BUTTON / TUNING DOWN (4) button to
advance HOUR until the correct time is displayed.
4. Press the SET MINUTE BUTTON / TUNING UP (3) button to
advance MINUTES until the correct time is displayed.
5. Press shortly the ALARM 1 / VOL- (6) or ALARM 2 / VOL+ (5) to
finish.
6. Press again shortly the ALARM 1 / VOL- (6) or ALARM 2 / VOL+
(5) button to select BU (Buzzer) or Radio to the activate or
deactivate the alarm type (when ON, the indicator will light up on the
right or left side of the display).
7. To switch off the alarm press repeatedly ALARM 1 / VOL- (6) or
ALARM 2 / VOL+ (5) until tthe indication light disappear.
To review the alarm after set, press and hold ALARM 1 / VOL- (6) or
ALARM 2 / VOL+ (5) button for 2 seconds. The Alarm time will be
blinking on the display. After 5 seconds, it will go back to normal time
display.
LISTENING TO THE RADIO
1. Press shortly the ON/OFF (2) button to switch the Radio ON
manually.
2. Press 2 seconds the TUN DOWN (3) or TUN UP (4) button to start