Installation & Assembly
1203
ASSEMBLY INSTRUCTIONS:
NOTE: Do not connect electricity until lamp is fully assembled.
1. Unpack all parts and remove packing materials. Place lamp base on a level
surface.
2. Remove nial (A) from harp (C). Squeeze harp (C) inward and place into
the opening of saddle (D).
3. Place shade (B) onto harp (C). Thread nial (A) back onto the harp to
secure the shade to the lamp.
4. Thread rods (E) into housing (F) until hand tight. Note: do not over tighten
as this could cause damage to rods.
5. Install one 150W max., type A, medium base bulb into the socket.
6. Remove protective plastic from plug (G).
7. Insert plug (G) into wall outlet.
IMPORTANT SAFETY INSTRUCTIONS:
* This lamp has a polarized plug (one blade is wider than the other) as a
feature to reduce the risk of electric shock. This plug will t in a polarized
outlet only one way. If it does not t fully in the outlet, reverse the plug. If
it still does not t, contact a qualied electrician. Do NOT alter the plug.
* Do not use with an extension cord unless the plug from the lamp can be
fully inserted into the extension cord receptacle.
* Switch power o and remove plug from the wall outlet before replacing
the bulb.
* This lamp is UL rated for dry locations.
ASSEMBLY INSTRUCTIONS FOR YOUR
ANDROMEDA FLOOR LAMP
**To clean, use a soft cloth only. Do not use any chemical or abrasive cleaners.**
(A)
(B)
(C)
(D)
(E)
(F)
(G)