Operation Manual

Alarms
Your radio has 2 separate alarms which can be set to wake you to DAB, FM radio, iPod or buzzer alarm. Each alarm can be set to sound once, daily,
on weekdays or at weekends. The alarms can be set whether the radio is on or in standby mode. In the event of a power interruption your radio has
a built in memory chip that will maintain your alarm settings for when the power is restored.
The way in which the alarm settings are accessed varies slightly according to whether you use the alarm buttons on the product or on the remote
control. The alarm buttons on the product may be used when the radio is in standby, or in use in DAB, FM, or Auxiliary Input modes (but not iPod or
Bluetooth modes). The alarm button on the remote control may be used when the radio is in use regardless of the operating mode, but it has a different
function when the radio is in standby - see page 33.
After gaining access to the settings for the chosen alarm (1 or 2) the setting method is the same for all operating modes of the product and you may use
the controls on the product or the buttons on the remote control equally. If no buttons are pressed for 10 seconds, the radio will exit the alarm setup.
29
Setting an alarm
1. To set an alarm using the controls on the product (if the radio is in standby,
or in DAB, FM or Auxiliary input mode) press and release the Alarm 1 or
Alarm 2 button. 'Alarm 1 Setup' or 'Alarm 2 Setup' will show on the display.
To set an alarm using the buttons on the remote control (if the radio is not in
standby) press and release the Alarm button once to enter Alarm 1 setup
and again to enter Alarm 2 setup.
2. Press and release the Select button to enter the setup for the chosen alarm.
The current alarm status will fl ash on the display.
3. Rotate the Tuning control (Tuning buttons on remote) to select On or Off. If
Off is selected any current setting for that alarm will be cancelled.
4. With 'On' selected, press and release the Select button to cause the alarm
hour digits to fl ash on the display.
5. Rotate the Tuning control (Tuning buttons on remote) to choose the desired
hour for the alarm and then press the Select button to cause the alarm minute
digits to fl ash on the display.
Alarm 1 Setup
Alarm 1 Wizard
Alarm On
Alarm 1 Wizard
On time
09:00
Alarm 1 Wizard
On time
09:30
1
3-5
2-5