Operation Manual

Controlling alarm status using the remote control

When your radio is in standby or whilst playing, the alarms can be controlled

using the Alarm button on the remote control.

1. To change the states of the alarms when the unit is in standby repeatedly

press and release the Alarm button on the remote control. The display

will cycle through all combinations of alarms on and off for both alarms.

To save the alarm status press and release the Select button. 'Alarm

Saved' will show on the display.

2. To change the states of the alarms when the unit is playing using

the remote control press and release the Alarm button. (Press and

release the Alarm button on the remote control once to enter Alarm 1

setup and again to enter Alarm 2 setup).

3. Press and release the Tuning Up or Down buttons to select alarm

On or Off.

4. Press the Select button to conﬁ rm the setting your radio will show

'Alarm Saved'.

Controlling alarm status using the product

When your radio is in standby or whilst playing the alarms can be controlled

using the alarm buttons on the product.

Note: If you wish to set the alarm whilst in iPod or Bluetooth mode you

will need to use the remote control, see below.

1. To change the states of the alarms, press and release the Alarm 1 or

2 button, 'Alarm 1 Setup' or 'Alarm 2 Setup' will show on the display.

2. Rotate the Tuning control to select alarm On or Off.

3. Press the Select button to conﬁ rm the setting your radio will show

'Alarm Saved'.

Alarm 1 Setup

Alarm

Saved

Alarm 1 Setup

Alarm On

1,2

Alarm

Saved

Alarm 1: On

Alarm 2: Off

Alarm 1 Setup

Alarm On

1,4