ISSUE EMD-EU2089 MODEL RU 2ZZ9990082 PRINTED IN JAPAN March 2005 CE-
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ05 WARNING : The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. NOTICE NOTICE To the engines exported to and used in the countries other than the U.S.A., warranty service shall be performed by the distributor in each country in accordance with the standard Robin engine warranty policy as applicable.
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ06 FEDERAL EMISSIONS COMPONENT DEFECT WARRANTY EMISSIONS COMPONENT DEFECT WARRANTY COVERAGE - This emission warranty is applicable in all States, except the State of California Fuji Heavy Industries Ltd. and Robin America Inc.
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ07 *The replacement parts used for required maintenance services. *Consequential damages such as loss of time, inconvenience, loss of use of the engine or equipment, etc. *Diagnosis and inspection charges that do not result in warranty-eligible service being performed. *Any non-authorized replacement part, or malfunction of authorized parts due to use of non-authorized parts.
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ08 CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS The California Air Resources Board and Fuji Heavy Industries Ltd. (herein "FUJI") are pleased to explain the emission control system warranty on your 2005 and later Small Off-Road engine (herein "engine"). In California, new engine must be designed, built and equipped to meet the State's stringent anti-smog standards.
EH025/035取説_米欧EU2089 05.3.
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ010 (4) repairs performed outside of the authorized warranty service dealers (5) use of parts which are not authorized by FUJI. 2. Add-on or modified parts This warranty does not cover any part that malfunctions, fails or is damaged due to alterations by changing, adding to or removing parts from the engine. 3.
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ011 (5) Miscellaneous Items Used in Above Systems (i)Electronic controls, if applicable (ii)Hoses, belts, connectors, and assemblies. (iii) Filter lock assy (gaseous fuel, if applicable) I.
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ013 FOREWORD ENGLISH (US) Thank you very much for purchasing a ROBIN ENGINE. Your ROBIN ENGINE can supply the power to operate various sorts of machines and equipment. Please take a moment to familiarize yourself with the proper operation and maintenance procedures in order to maximize the safe and efficient use of this product. Due to constant efforts to improve our products, certain procedures and specifications are subjected to change without notice.
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ014 CONTENTS 1. SAFETY PRECAUTIONS ・・・・・・・・・・・・・・・・・・・・・・・・・・・・1 2. COMPONENTS ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・4 3. PRE-OPERATION CHECKS ・・・・・・・・・・・・・・・・・・・・・・・・・・7 4. OPERATING YOUR ENGINE ・・・・・・・・・・・・・・・・・・・・・・・・・8 5. EASY TROUBLESHOOTING ・・・・・・・・・・・・・・・・・・・・・・・・・10 6. MAINTENANCE SCHEDULE ・・・・・・・・・・・・・・・・・・・・・・・・・11 7. "HOW-TO" MAINTENANCE ・・・・・・・・・・・・・・・・・・・・・・・・・・13 8. PREPARATIONS FOR STORAGE・・・・・・・・・・・・・・・・・・・・・17 9.
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ015 SYMBOLS Read the owner's manual. Stay clear of the hot surface. Stop the engine before refueling. Fire, open flame and smoking prohibited. On (Run) Plus ; positive polarity Off (Stop) Battery Engine oil Engine start (Electric start) Add oil ENGLISH (US) Exhaust gas is poisonous. Do not operate in an unventilated area.
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ1 1. SAFETY PRECAUTIONS Please make sure you review each precaution carefully. Pay special attention to statement preceded by the following words. WARNING “WARNING” indicates a strong possibility of severe personal injury or loss of life if instructions are not followed. CAUTION “CAUTION” indicates a possibility of personal injury or equipment damage if instructions are not followed. WARNING : EXHAUST PRECAUTIONS ■ Never inhale exhaust gasses.
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ2 WARNING : OTHER SAFETY PRECAUTIONS ■ Place the protective covers over the rotating parts. If rotating parts such as the drive shaft, pulley, belt, etc. are left exposed, they are potentially hazardous. To prevent injury, equip them with protective covers or shrouds. ■ Be careful of hot parts. The muffler and other engine parts become very hot while the engine is running or just after it has stopped.
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ3 CAUTION : PRE-OPERATION CHECKS ■ Carefully check fuel hoses and joints for looseness and fuel leakage. Leaked fuel creates a potentially dangerous situation. ■ Check bolts and nuts for looseness. A loose bolt or nut may cause serious engine trouble. ■ Check the engine oil and refill if necessary. ■ Check the fuel level and refill if necessary. Take care not to overfill the tank. ■ Keep cylinder fins and recoil starter free of dirt, grass and other debris.
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ4 2. COMPONENTS EH025 Plug cover Air cleaner Stop switch Clutch P.T.O. Shaft Fuel tank A Type P Type (Pump) Choke lever Carburetor Muffler Primer pump Oil gauge (Oil filler) Starter handle Recoil starter Engine serial No.
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ5 EH035 Plug cover Air cleaner Clutch Fuel tank cap Fuel tank P.T.O.
EH025/035取説_米欧EU2089 05.3.
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ7 3. PRE-OPERATION CHECKS CHECK ENGINE OIL Before checking or refilling engine oil, be sure the engine is located on a stable, level surface and stopped. Oil gauge Do not thread the gauge into oil filler to check oil level. ■ If the oil level is below the lower level line on the dipstick, refill with the proper oil (see table) up to the upper level (up to the point of overflowing the filler neck).
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ8 4. OPERATING YOUR ENGINE STARTING PRIMER PUMP STOP SWITCH 3 1 ON ON ■ Set the throttle lever to the idling position. ■ If the stop switch is installed on the engine.Set the stop switch to the position "ON or I ". ■ Push the primer pump 7 to 10 times to feed the fuel to the carburetor. If the stop switch is installed on a machine side.Set the stop switch to the position "ON or I ".
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ9 STOPPING STOP SWITCH CHOKE LEVER 1 5 ON OFF OFF ■ ■ After starting the engine, gradually open choke by turning the choke lever and finally keep it fully opened. ■ Set the throttle lever at the low speed position and allow the engine to run at low speed for 2 or 3 minutes before stopping. ■ If the stop switch is installed on the engine.Set the stop switch to the position "OFF or O ". ■ If the stop switch is installed on a machine side.
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ10 5. EASY TROUBLESHOOTING WHEN ENGINE DOES NOT START: Perform the following checks before you take the engine to your Robin dealer. ■ If you still have trouble after completing the checks, take the engine to your nearest Robin dealer. ■ Is the engine switch set ON? 1. Pull the starter handle slowly and check if resistance is felt. 2. If little force is required to pull the starter handle, check if the spark plug is tightened firmly. 3.
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ11 6. MAINTENANCE SCHEDULE MAINTENANCE, REPLACEMENT OR REPAIR OF EMISSION CONTROL DEVICES AND SYSTEMS MAY BE PERFORMED BY ANY NON-ROAD ENGINE REPAIR ESTABLISHMENT OR INDIVIDUAL. DAILY INSPECTION Before running the engine, check the following service items.
EH025/035取説_米欧EU2089 05.3.
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ13 7. "HOW-TO" MAINTENANCE INSPECTING THE SPARK PLUG ■ Clean off carbon deposits on the spark plug electrode using a plug cleaner or wire brush. ■ Check electrode gap. Adjust gap 0.7 mm to 0.8 mm (0.03 inches) ■ Use a proper spark plug : 0.7 to 0.8 mm (0.03 in.) NGK CMR6A ENGINE OIL CHANGE ■ Initial oil change After 20 hours of operation ■ Thereafter Every 50 hours of operation ■ Refer to the recommended oil table on page 7.
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ14 3) Remove the oil gauge, then tilt the engine and drain the oil into a pan or other receptacle. (EH035V) Remove the oil drain screw and drain the oil. 5) After filling the engine with oil, reinsert the oil gauge. Ensure that the oil gauge is tight, as if it loosens later oil will leak out. ADJUSTING CARBURETOR Adjusting idling rpm When adjust screw is turned right, engine rpm increases, and when it is turned left, rpm decreases. (Refer to illustration.
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ15 CLEANING FUEL FILTER Remove the hose clamp and pull out the fuel filter from fuel pipe. Wash the fuel filter with kerosene. After washing, reassemble it. If the fuel filter is heavy dirty, replace it with new one. CLEANING AIR CLEANER EH025 Place so that the cutout is here (top left) Choke lever Element Breather Dirty air cleaner element will cause starting difficulty, power loss, engine malfunctions, and shorten engine life extremely.
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ16 CHECKING BOLTS, NUTS AND SCREWS FUEL PIPE REPLACEMENT Replace the fuel pipe every 1 year. If the fuel leakage is found on the fuel pipe, replace it immediately. - 16 - ENGLISH (US) Retighten loose bolts and nuts. Check for fuel and oil leaks. Replace damaged parts with new ones. Keep safety in your mind.
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ17 8. PREPARATIONS FOR STORAGE DISCHARGE FUEL (NO SMOKING !) In case the engine is not going to be used for more than one month, discharge fuel thoroughly from fuel tank and carburetor in order to prevent from hard starting and/or poor engine operation due to deteriorated fuel when you use the engine next time. ■ Pour out the fuel in the tank from its filler neck. ■ Push the primer pump of the carburetor until the fuel in it is thoroughly discharged.
EH025/035取説_米欧EU2089 05.3.7 6:11 PM ページ18 9. SPECIFICATIONS MODEL EH025A EH025P EH035A EH035P EH035V Air-Cooled, 4-Stroke, Single Cylinder, Overhead valve, Gasoline Engine Type in.(mm) 1.34 x 1.06 (34 x 27) 1.54 x 1.10 (39 x 28) cu. in. (cm3) 1.49 (24.5) 2.04 (33.5) Maximum Output kW (HP) / rpm 0.81 (1.1) / 7000 1.18 (1.6) / 7000 Maximum Torque N・m (kgf・m)/ rpm 1.18 (0.12)/ 5000 1.76 (0.18)/ 5000 Displacement Counterclockwise as viewed from P.T.O.
EH025/035取説_米欧EU2089 05.3.
