Installation and Operation Guide

ManualsBrandsRobinhood ManualsGarment Care and IronsSurface Mounting Kit

Description: ROBINHOOD IRONING CENTRE SURFACE MOUNTING KIT

Model Numbers: ICSMK

Thank you for purchasing a quality Robinhood ironing surface mounting kit. This kit is designed to fit a surface

mounted IC1300 Ironing Centre.

Important:

o Please read the entire instructions before installing the ironing centre/surface mounting kit.

o Please allow 100mm clear area on either side of ironing centre for surface mounting kit installation.

o (Alternatively install surface mounting kit to Ironing Centre before installing to the wall)

o Should you be fitting a door to the enclosure holding this product, please be mindful of the position of all door

furniture (hinges, handles etc). Specifically ensure the board will operate without obstruction.

o Do not place EXCESSIVE WEIGHT (weight should not exceed 15kg) on the ironing board when opened, as it is

designed to only accept normal ironing use only.

o The product is not intended for use by small children or infirm persons without supervision.

Contents of packaging:

2 x collar sides (A)

1 x collar top (B)

1 x collar bottom (C)

1 x instructions

1 x packet of fasteners

- 2 x edge covers(D), 8 x small screws size 6” x ¼”(E), 6 x large screws size 8” x ¾”(F), 1 x edge saddle (G)

Pre-installation

Collar Kit Assembly

ICSMK

Issue: 3

Typical equipment required:

o electric drill

o screwdriver

o tape measure

o spirit level

DIAGRAM 1

EDGE COVER

POSITION

REAR VIEW

IC1300

Summary of content (4 pages)

PAGE 1
ICSMK Issue: 3 Description: ROBINHOOD IRONING CENTRE SURFACE MOUNTING KIT Model Numbers: ICSMK Pre-installation Thank you for purchasing a quality Robinhood ironing surface mounting kit. This kit is designed to fit a surface mounted IC1300 Ironing Centre. Important: Please read the entire instructions before installing the ironing centre/surface mounting kit. Please allow 100mm clear area on either side of ironing centre for surface mounting kit installation.
PAGE 2
Surface Mounting Kit Assembly to IC1300 Ironing Centre Note - this kit is interchangeable to allow the power cord to exit at either the top or bottom of the unit. Just swap part (B) with part (C) during installation and take note of power cord route. Follow the Ironing Centre installation instruction to mount the Ironing Centre to the wall. Instructions for fitting the collar with power exiting at the bottom. 1. Clip the edge covers (D) into position (Diagram. 1). 2.
PAGE 3
Warranty Certificate (New Zealand) Terms and Conditions The following conditions apply in respect of the warranty given in this certificate: 1. Monaco Corporation Limited (“Monaco”) warrants the following Robinhood products against manufacturing defects and faulty materials, under normal use and subject to the exclusions in this certificate, for a period of: Rangehood, Ovens, Cooktops, Dishwashers - 24 months from date of original purchase for domestic use.
PAGE 4
Warranty Certificate (Australia) Terms and Conditions If you are a consumer under the Australian Consumer Law, our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure 1.