Technical data

6.2.3 For the ‘Manual’ version, remove the burner tray by
removing the two screws.
Refer to Fig 11b.
6.2.2 Remove the fender mask by removing the two screws.
Refer to Fig 11a.
10
Fig 11a.
6.2.4 For ‘Slider’ version, release the ‘link arm’ at the
lower R.H. Side. Set control to ‘Medium setting’ and
remove connecting screw. Allow ‘link arm’ to rest on
support plate.
Refer to ‘enhanced view’ of Fig 12.
Then remove the burner tray by removing the two
screws, taking care not to damage the ‘link arm’.
Refer to Fig 12.
Fig 12.
link arm
Connecting screw
Support plate
Please ensure the control is at the ‘Medium’ setting (marked ’II’) for ease of re-assembly.
Fig 11b.