Technical data

The Fuel Effect pack contents are illustrated in Figs 2a & 2b.

The fire is supplied with the rear brick effect panel already

fitted.

Unpack the Fuel Effect components and check that these are

undamaged.

DO NOT INSTALL THE FIRE WITH BROKEN OR MISSING

FUEL EFFECT COMPONENTS.

USE ONLY THE FUEL EFFECT COMPONENTS SUPPLIED

WITH THE FIRE.

The underside of the base ceramic matrix has grooves

matching the raised ports of the burner top. Fit the

matrix by placing it onto the burner. Take care to avoid

damage as you insert it past the pilot burner (Refer to

Fig 22.). Ensure that it is correctly located in the burner

tray by sliding it sideways and front to back.

Insert the side cheeks by sliding them down the side of

the matrix until they touch the rear brick effect panel.

(Refer to Fig 23.)

Lower the centre ceramic into position as shown in

Fig 24. The front edge of the centre ceramic must be

flush with the back edge of the of the sides of the base

ceramic matrix.

Pivot the centre coal backwards until the top back edge

of the centre coal touches the back brick( Fig 25.).

Fig 25

Fig 22

Fig 23

Fig 24

14.0 INSTALLATION OF FUEL EFFECT COMPONENTS

This procedure is the same for both pebble and coal

versions (coal illustrated).