Technical data

22
Position pebbles (B) and (E), then locate (C) centrally
on the bed.
Locate pebble (M) and (N) at the sides, supported
between (J) & (O) and (L) & (O) respectively.
Finally position pebbles (D) & (F) as shown in fig 28a.
O
O
O
G
H
A
Fig 26a
O
O
O
G
H
A
J
L
I
K
Fig 27a
M
N
D
F
B
C
E
J
L
G
H A
Fig 28a
In the unlikely event of failure of the ignition spark the fire can
be lit with a taper or a long spill.
Remove the trim assembly. Pull lower sides off retaining
magnets and lift to unhook top. Place carefully to one side.
You should be able to see the pilot burner just below the base
ceramic matrix, to the left of centre.
Light your taper and apply it to the pilot burner. Depress the
control knob to the PILOT position.
The pilot, and main burner at low, lights and you should keep
the knob depressed for 10 seconds before releasing. The fire
should remain alight.
Before setting the fire to full heat input,replace the trim
assembly by hooking over top of fire back and lowering bottom
of sides onto retaining magnets.
14.2 LIGHTING WITH A TAPER
APPLY TAPER HERE
14.1 PEBBLE LAYOUT
Position 3 pebbles (O) on each of the platforms on the
centre coal.
Arrange pebbles (G), (H), and (A) along the front of the
base ceramic matrix as shown in fig 26a.
Support pebbles (I) and (K) on the (O) pebbles.
Locate (J) and (L) on either side of the fuel bed (See fig
27a).