Technical data

Fig 26b

Fig 27b

Fig 28b

Fig 29b

14.3 COAL LAYOUT

Position the four separately packed coals in the

corresponding indentations on the front edge of

the base ceramic matrix. See fig. 26b.

NOTE: On later removal of loose coals, keep

separate the four front coals (see fig 26b) for

correct replacement.

Position a coal on each of the platforms on the center

ceramic as shown in Fig. 27b.

Place a coal on either side, resting on the side of the

base ceramic matrix and the loose coal beside it. Next

to this, bridge the gap between the front and the middle

row either side of the center. The central coal is then

positioned resting on the front coals and node on the

center ceramic.

Position a coal vertically on the center ceramicl

supported by the coals resting on the nodes. Refer to

Fig. 28b.

Place the final layer of four coals, carefully - as shown

in Fig. 29b.