Owner's Manual
9
Contents
(1)
Pair Marine Grade Speakers
(1)
Pair Removable Marine Grade Sport Grills
(1)
Pair
of
Stainless Steel Grill Inserts
(13)
Socket head stainless screws
(2)
Socket head driver
bit
(2)
RGB
Harness
(1)
PairofM2-TS Tweeters
(M2
-
TS
ONLY)
(1)
Pa
ir External lBdB/Oct Crossover(M2-
TS
ONLY)
(1)
Pair Flush Mount Clamps(M2-TS
ONLY)
(1)
Pair Horn Loading Mounting Flange
w/
O-rings(M2-TS
ONLY)
Installation
Considerations
Before beginning
any
installation, follow these simple rules:
Be
sure to carefully read
and
understand the instructions
before
attempting
to install these speakers.
For easier assembly, we suggest you run
all
wires
prior
to
mounting
your
speakers in place.
Use
high
quality
connectors for a reliable installation
and
to minimize signal
or
power
loss.
Think before you drill!
Be
careful
not
to
cut
or
drill
into gas
tanks, fuel lines, brake
or
hydraulic lines, vacuum lines
or
electrical wiring when working on
any
vehicle.
If
installation
in a boat, take care
not
to
cut
or
drill
through the main
hull
.
Never run wires underneath the vehicle. Running the wires
inside the vehicle
or
hull
area provides the best protection.
Avoid running wires over
or
through sharp edges.
Use
rubber
or
plastic grommets to protect
any
wires routed
through metal, especially the firewall.
Installation
Mounting
Determine where the speakers
will
be mounted. Ensure an
area large enough for the speaker to
mount
evenly.
Be
sure
that
the mounting location
is
deep enough for the speaker
to fit;
if
mounting in a door, operate
all
functions (windows,
locks, etc.) through their entire operating range to ensure
there
is
no obstruction.
Refer to the specification
chart
to determine the proper
diameter hole to
cut
for
your
speaker model. Cutting
and
mounting templates can be found
at
www
.rockfordfosgate.
com.
Mark the locations for the mounting screws. Drill the holes
with a
1/8
" bit.
Feed the speaker wires through the
cutout
and
connect to
the speaker terminals.
Be
sure to observe proper
polarity
when connecting the wires.
The
speaker's positive terminal
is
indicated with a "+'
'.
Fit the trim ring over the speaker
and
mount
into place
using the four
(4)
screws
that
are provided.
Tighten the screws
until
the speaker
is
snug in place to
prevent
rattling
.
Do
not
over tighten the screws.