User's Manual

10
WIRING: 18-PIN Connector Cont.
BLUE/WHITE: (-) 500mA Remote Aux. Output 2 (Programmable Option #10)
This is a programmable output that can operate 4 different ways.
1. Channel 2 = 2
nd
Unlock Hold 2 Sec. - Default. Hold Unlock Button for 2 seconds to unlock passenger doors.
2. Channel 2 = 2
nd
Unlock Double Press. Press Unlock button 2 times to unlock passenger doors.
3. Channel 2 = Momentary Hold. This is a momentary output as long as the remote button is pressed.
4. Channel 2 = 30 Second Timer.
BLACK/WHITE: (-) 500mA Remote Aux. Output 3 (Programmable Option #11)
This is a programmable output that can operate 4 different ways.
Channel 3 = Dome Light - Default. For Dome light Supervision with unlock.
Negative Dome Light System: Connects to terminal 85 of a relay. Connect terminal 86 to +12V Constant.
Connect terminal 87 to Chassis Ground. Connect Terminal 30 to the Negative dome light activation circuit.
Positive Dome Light System: Connects to terminal 85 of a relay. Connect terminals 86 & 87 to +12V Constant.
Connect terminal 30 to the Positive dome light activation circuit.
BROWN/WHITE: (-) 500mA Remote Aux. Output 4 (Programmable Option #12)
This is a programmable output that can operate 4 different ways.
Channel 4 = Horn Honk - Default. Connect to the Negative Horn Trigger wire usually located near the steering
column. If the vehicle horn circuit requires +12 volts, a relay is required. RELAY WIRING: Connect the Brown/White
wire to terminal 85, connect relay terminals 86 and 87 to +12V constant power. Connect terminal 30 of the relay to
the +12V positive device/circuit to be activated.
ORANGE WHITE: (-) 500mA Remote Aux. Output 5 – ACCESSORY or OEM REARM
(Programmable Option #13)
This is a programmable output that can operate 4 different ways; see option #13.
Channel 5 = Accessory - Default. Controls 2
nd
Accessory Output for Remote Start. RELAY WIRING: Connect the
Orange/White wire to terminal 85, connect relay terminals 86 and 87 to +12V constant power. Connect terminal 30
of the relay to the 2
nd
Accessory wire of the vehicle. Channel # 5 can be programmed for OEM REARM. This
option provides a ground pulse to rearm the vehicles' FACTORY anti-theft system after a timed-out or aborted
remote start. Connect this wire to the vehicles' anti-theft rearm wire or to the door pin circuit depending on your
requirements. This wire may be needed to pulse the door pin circuit on vehicles with retained accessory power.