User's Manual

PROGRAMMABLE OPTIONS

You can program multiple options in one session if you start with the lowest option and continue on to higher options

without repeating steps #1-3 below. For example, you can follow the programming steps to change an Option by

pressing button 1 to 4 on the remote, then you can continue pressing the program button additional times to get to a

high number option and change the setting without having to repeat Steps 1-5. You can only go from low to higher

option numbers in one session.

To Engage Option Programming:

1. Turn Ignition Key to the ON position

2. Press Program / Valet button 5 times, after a few seconds the unit will flash the lights and Siren Chirps 5 times.

3. Push the valet/program button [again] the number of times that corresponds to the option number desired (1 thru

28). You must get a light flash and chirp after each button press.

4. When you reach the desired programming level, Press button #1, #2 #3 or #4 to change the option level. The

siren and horn will confirm with 1-4 chirps. The remote control will confirm program option selection on top

right corner of display. Example option #6 button 4 shows *06--4

5. Turn Ignition OFF and check for changed features.

Note: The Program Mode Exits automatically after 20 seconds (lights flash 4 times on exit).