User's Manual

PROGRAMMABLE OPTION Cont.

Manual Transmission Exit Procedure:

1. Option 26-2: With engine running and vehicle in neutral, set parking brake, then press “Idle Down” Icon or

remote start on transmitter. The remote starter will turn on and take over operation of the vehicle.

2. Option 26-3: With engine running and vehicle in neutral, set parking brake. The remote starter will turn on and

take over operation of the vehicle.

3. Remove key, exit vehicle (remote starter unit must “SEE” door opened, then closed with engine running).

4. Press Lock button within 10 seconds of closing door to arm system with “Idle Down” (engine stays running).

Press Lock a 2

time to cancel “Idle Down” (engine turns off) and set up Manual Transmission Mode.

5. Press Lock button after 10 seconds to Arm system, lock the doors and shut down the engine. From this point,

the system will remote start the engine unless a door is opened or the alarm is triggered (either function will

cancel the remote start sequence).

27. REMOTE CARJACK:

This option is used to enable Carjack Protection. Carjack is enabled by the remote control or Valet button while the

ignition is on and the doors are closed. Remote Carjack starts a 30 second countdown to trigger alarm. The Valet

button enables Passive Carjack, the door must open and close to start 30 second countdown. The Default = ON.

28. FACTORY DEFAULT: OPTION RESET

This resets all options to Factory Default. Press button #1 on the remote control to restore all Factory Defaults.

This system option restores all options to FACTORY DEFAULT VALUES as listed in the “Button #1” column of the

programmable option chart on pages 23-24. This can be helpful if you have lost track of the option settings on your

system, or when you are moving the system from car to car and want a “clean slate”.

1. Turn ignition Key to the ON position.

2. Press program / valet button 5 times, after a few seconds the unit will flash the lights 5 times.

3. Push the valet/program button 28 times. You must get a chip and light flash each time you press the button. If the

unit didn’t flash the lights, then the system did not register your press.

4. Press button #1 (Lock) to reset the options. The lights, horn and siren will flash once.

5. The remote control will confirm with “RESET” on the top right corner of display.

6. Turn Ignition OFF. All features will be set at *DEFAULT values.