User's Manual

ALARM TRIGGER DIAGNOSTICS

This systems includes disarm diagnostics, through the LED light, that will help in determining what caused the last

trigger of the alarm system. This is a valuable tool in determining how the vehicle was tampered with or if there is a

false alarm problem in which case you can make the necessary adjustments to correct the problem.

When the system is disarmed with the remote you will hear 4 quick chirps that indicate the alarm was triggered while

you were away. Check the LED light for a sequence of flashes:

Shock Sensor Violation = 2 Flashes Sensor 2 Violation = 3 Flashes

Trunk Violation = 4 Flashes Door Violation = 5 Flashes

Hood Violation = 6 Flashes Ignition Violation = 7 Flashes

Diagnostics will reset when the Ignition is turned on or when the system is re-armed.

REMOTE START DIAGNOSTICS

If the system doesn’t remote start, the Status LED flashes an error code to identify the problem area.

• SOLID LED = Valet Service Mode. Check the systems LED light and if it is on solid Red LED (with doors

closed) then the system is in Valet Mode. To exit Valet Mode, turn the Ignition on, press and hold Valet Button

for about 5 seconds until LED goes out. Unit is now out of Valet Mode and should perform a remote start.

• 2 LED Flashes = Problem with Hood Switch. Make sure hood is closed or that the Blue hood pin wire is not

shorted to Ground.

• 3 LED Flashes = Problem with Brake Switch. There could be a problem with a bad brake light. Many dual

filament light bulbs connect the brake and park lights together when bulb goes bad. Check all brake lights

work properly. If using hand brake (normally closed circuit), but sure hand brake is set.

• 4 LED Flashes = Low Battery Voltage. Charge vehicle battery. Battery voltage below 11.5 volts.

• 5 LED Flashes = Ignition On before Remote Start.

• 6 LED Flashes = Tach Problem. Try reprogramming Tach mode, the RPM is too low or high. Move Tach

source.

• 7 LED Flashes = Manual Transmission Error.

• 8 LED Flashes = Diesel Wait to Start Time Out. Check for proper polarity of glow plug circuit.

• 9 LED Flashes = Remote Start Failed 4 Times.