User's Manual

8
WIRING: 18-PIN Connector
BLUE/ORANGE: (-) 500mA Starter 2 Output
Some vehicles require a 2
nd
start wire for remote start.
BLUE/ORANGE
CONNECT TO IGN
85
86
+
-
30 87
BATTERY
STARTER
ORANGE: (-) 500mA Starter Kill / Anti-Grind Output
This wire should be connected to the Black wire of the pre-wired relay socket for the starter disable. Connect the
Red wire of the relay socket to the Ignition switched wire on the vehicle. Cut the vehicle starter wire and connect
each half to the Yellow and Blue wires on the relay socket as shown. This output also turns on with remote start to
function as an “Anti Grind” wire to prevent the starter from grinding if you get in your car and turn the key too far
after it was remote started. See starter disable diagram on next page.
CUT
STARTER WIRE
STARTER
YELLOW
BLUE
CONNECT TO
PRE-WIRED
OF ALARM
IGN. SWITCHED
RED
BLACK
ORANGE WIRE
STARTER DISABLE
RELAY & SOCKET
IGNITION SWITCHED
"ON" & HOT THROUGH
CRANKING
BROWN
START OUTPUT
6-PIN HARNESS
FROM ALARM
MAKE CERTAIN TO
CONNECT BROWN
WIRE TO STARTER
MOTOR SIDE!!!
STARTER DISABLE: