User's Manual

15
24. Learn tachometer (RPM)
- turn on ignition
- press override button 6 times,
- wait 2s, parking lights flash and siren chirps 6 times
- press override button 1 times,
- siren chirps one time
Start the vehicle with the key. while the engine is running, the parking will flash. if don’t, please check
tachometer wire connection.
Press on transmitter to record the RPM. Chirp once to confirm. And exit the RPM learn mode.
Press on transmitter to exit the RPM learn mode. chirp 4 times and flash 4 times
25. Remote engine start
Press and hold 2 sec. button
to remote engine start, parking light flash twice to confirm. If engine isn’t
started up from first, the system will automatically total start the engine 4 times. Cranking time (program
feature 19) of each next attempt will be increased by 0.2 sec.
If start is successful. parking lights flash 3 times
Engine runs during “running time”. Then shut down automatically.
To stopping engine press button hold 2 sec. Parking flash once for confirm.
During engine is running, press to add engine running time. Engine running increased 10 minutes
The maximum can extend to 120 minutes
* Remote engine start failure indicator
LED flash 2 times, HOOD OPEN
LED flash 3 times, HAND/PEDAL BRAKE ERROR
LED flash 4 times, IF CAR BATTERY VOLTAGE IS LESS THAN 11.5V
LED flash 5 times, RPM is run.
LED flash 6 times, RPM TOO SLOW OR HIGH
LED flash 7times MANUAL GEAR CAR NO MID GEAR PROCEDURE
LED flash 8 times, DIESEL WAIT TIME OUT
LED flash 9 times, TRY 4 TIMES FAIL