User's Manual

16
26. Learning codes of remote transmitter
There are only four transmitters may be learned in system’s memory.
Codes of learned remote transmitters will be erased each time the learning mode is activated.
To activate leaning codes mode:
- turn on ignition
- press override button 4 times
- wait 2 seconds, parking lights flash and siren chirps 4 times
- press button of first remote transmitter
- siren chirps and remote transmitter beeps once
- press button of second remote transmitter
- siren chirps and remote transmitter beeps two times
- press button of third remote transmitter
- siren chirps and remote transmitter beeps 3 times
- press button of fourth remote transmitter
- siren chirps and remote transmitter beeps 4 times
After 20 sec or turning off ignition system will get out the Learning codes of remote transmitter procedure,
parking lights flash 4 times.
27. MANUAL TRANSMISSION EXIT PROCEDURE:
1. With engine running, parking brake set and vehicle secured in neutral, press and hold 2 sec the
button (or Idle Down button) on transmitter. The remote start system will unlock the doors, and “take-over”
operation of the vehicle.
2. Remove ignition key and exit vehicle.
3. 10 seconds after closing all doors, press the
button. The system will now shut down the engine,
lock the doors and Arm the alarm system. From this point, the unit will start the engine unless the alarm was
triggered and/or a door was opened.
hand brake not set SIREN chirp 3 times engine not running SIREN chirp 5 times
•
Turbo Timer on Manual Transmissions
Make option to have engine turn off after Turbo timer is finished (instead of turning off with lock). When
button is pressed, the parking lights start flashing to signal manual transmission mode and the engine
turns off after Turbo Timer. This would only be for Manual Mission with Turbo Timer