User Manual

DIESEL GLOW PLUG DELAY

There are 2 methods of setting up a Glop Plug delay for Diesel vehicles.

1. Connecting the Pink wire directly to the wait to start lamp on vehicle. Option 23-3 must be selected for Pink

wire = Glow Plug. Also, Option 20-4 must be selected for 20 seconds maximum wait time (default = 4 sec.).

With this option selected, the starter will crank when the Wait-to-Start light turns off.

2. Option 20 – Pre-Set Diesel Glow Plug Delay, The choices are 4, 10, 15 and 20 seconds. This feature provides

a solution for diesel vehicles without having to connect to the Glow Plug Wait-to-Start Circuit. This may be

needed for various reasons. If your vehicle does not have a valid Wait to Start wire (LED light on instrument

cluster), or you cannot locate and identify the circuit, then change your system to Diesel Glow Plug Delay.

Once this mode is activated, you no longer need to connect up the Wait-to-Start wire.

NOTES: This feature is OFF by default and must be programmed before use. There are 4 different Delay times

available for use: 4, 10, 15, or 20 seconds. Default = 4 Seconds. SEE OPTION PROGRAMMING

OPTION PROGRAMMING - 2 METHODS

This System unit has 25 programmable options to customize the system for various operating features and installer

preferences. There are 2 methods of programming option for this system. You can use a PC with the optional

Program Cable or the Valet program switch that comes standard with the system. Examine the chart on the

following pages along with reading the descriptions that follow. You may change one option at a time, or program

multiple options in one session. If you start with the lowest option and continue on to higher options, you do not

need to repeat steps #1-3 each time. For example, you can change Option #2 to “ON”, then you can continue

pressing the program button to get to a higher number option and change it as well. You can only go from low to

higher options numbers in one session. There is a 20 second time out with no activity. The system will give one log

parking light flash and or horn honk when exiting program mode.

OPTION PROGRAMMING CHART BEGINS ON NEXT PAGE