User Manual

3
INSTALLATION CAUTIONS & WARNINGS
DO NOT extend the Remote start ignition harness length. Mount the module so that main harness reaches all
ignition switch wiring. Extending these wires could result in poor or improper performance.
DO NOT route any wiring that may become entangled with brake, gas pedals, steering column or any other moving
parts in the vehicle.
DO NOT exceed the rated output current of any circuit on the Remote start module. Failure to observe this warning
will result in damage to the unit not covered under warranty.
DO NOT remote start the vehicle in a closed garage! Make sure that the garage door is open or there is adequate
ventilation. Failure to observe this rule could result in injury or death from poisonous Carbon Monoxide fumes.
WIRING Low Current 14 Pin Plug
BLACK: MAIN SYSTEM GROUND
Connect to chassis metal of the vehicle. An existing bolt or screw may provide an adequate ground, or drill a small
hole, scrape away paint and attach using a sheet metal screw & star washer. This wire must be connected to a
proper ground or undesirable and inconsistent operation will occur. Do not use Factory ground locations.
YELLOW: (-) HORN HONK OUTPUT (Programmable 15, 20 and 30 milliseconds)
Connect to the Negative Horn Trigger wire usually located near the steering column. If the vehicle horn circuit
requires 12V, then a relay is required. RELAY WIRING: Connect the yellow wire to terminal #85, Connect relay
terminals #86 and #87 to 12V constant power. Connect terminal #30 to the 12V positive Horn activation wire.
YELLOW/BLACK: (-) GROUND OUTPUT WHEN RUNNING
The Ground When Running output is used for Anti-theft and Transponder Bypass modules. It can be used for a Anti
grind / Starter Disable. This wire turns on when the remote start button is pressed and stays on through the duration
of the remote start. When using this wire for an Anti grind/Starter disable, an optional Relay is needed to interrupt
the Starter circuit. The starter disable circuit prevents accidental grinding of the starter if key is turned too far after a
remote start. This required an optional Diode, see diagrams on NEXT PAGE.