Product Manual

PLEASE SEE OTHER SIDE FOR IMPORTANT SAFETY WARNINGS
1. Measure the interior length and width of your drawer.
2. Decide whether you want your organizers to run front to
back or side to side.
Check Rockler.com for updates. If you have further questions, please
contact our Technical Support Department at 1-800-260-9663
or [e-mail]
3. Determine which components you need for the configuration
you want. Set up some of the components to get a sense
for how they will fit and to measure where they will need
to be trimmed.
4. Mark and cut the tray sections to fit your drawer using
standard scissors. Cut along the grid pattern on the bottom
to preserve continuity of spacing and alignment. Fig. 1.
5. Connect the tray sections by fitting the notches under the
wall edge of one tray section onto the rectangular teeth on
the lip edge of another. The two interlock to register the
sections so the dividers and bins will be perfectly aligned.
Fig. 2. (You can use double-sided tape under the tray
sections to hold them in place, if you want.)
6. Install the dividers and bins in the desired locations. Splines
on the divider edges and the bin sidewalls slide into slots in
the tray section walls, and the hooked tops fit over the ridges
at the top of tray sections for a secure connection. Fig. 3.
Effective May 2018
To avoid injury, exercise care when
using scissors.
When assembled, the Starter Kit measures
14
5
⁄16" wide x 13" deep, and one wide tray section equals the
width of two interlocked regular tray sections.
Failure to use the grid system on the
underside of the tray sections as a cutting guide is likely
to lead to misalignment and unsatisfactory results.
Fig. 3
Fig. 2
Fig. 1
Installation Instructions