User`s manual

INPUT JACKS - LOW AND HIGH

Connect the output of your guitar to one of the 1/4”input jacks with a shielded guitar cable. Select

LOW for normal, or HIGH for extra gain. Plugging into the LOW input will attenuate your guitar’s

signal cooling down a “hot” guitar. These two jacks provide slightly different input levels. Experi-

ment with these and adjust to your tastes.

PREAMP GAIN - DRIVE

Turning this knob clockwise determines the amount of gain (or distortion) added to the signal.

PREAMP GAIN - CLEAN

This knob controls the Clean Channel Level.

CH SELECT - Button & DRIVE LED

Channel Select button - allows you to select between the DRIVE channel or the CLEAN channel.

The DRIVE LED is ON (or lit) when the DRIVE channel is active.

MASTER - Volume Control

The MASTER volume control adjusts the overall sound level.

REVERB control

Adjusts the amount of reverb added to your guitar’s signal. Turn the knob clockwise to increase the

effect.

CHORUS button and ON/RATE LED

Push in to activate the CHORUS. The ON/RATE LED is illuminated when CHORUS is ON and

flashes to indicate RATE speed.

DEPTH control

Controls the modulation depth for the CHORUS effect. Lower DEPTH settings (counterclockwise)

produce a more subtle detune effect, while higher settings produce a more extreme detuning effect.

TREBLE/MID/BASS controls

Tone controls or EQ. The BASS control boosts or cuts the amount of low frequency, or bass sound.

Treble does the same for high frequencies, MID adjusts the midband frequencies.

1 2 3 4 5 6 7 8 9 10 11 12 13

RATE control

This controls the delay time for the CHORUS effect. Lower RATE settings result in slower sweep

speeds. Higher settings result in faster speeds. The ON/RATE LED flashes to indicate the rate of the

speed of the sweep.