User`s manual

Built-in Chromatic Tuner Functions

On/Off button

Press this button to engage the tuner function. When tuner is on the LED lights will be on depending

on the note you play.

A.CALIB. button

A.Calib = Auto Calibration. To match the pitch of any instrument or audio source (like an old piano

or tape player) press the auto calibration button while playing the note on the instrument. (Note: you

might have to first tune one string on the guitar by ear to match the actual note if the piano is out of

standard tuning or if tape player you are playing along with runs slower or faster than normal). Once

you have one note on the guitar tuned to the source - simply play that note on the guitar - while the

note is “ringing” press the Auto Calibration button. The tuning pitch of the tuner will automatically

be shifted the match the pitch of the audio source. Release the button and tune the remaining strings

as normal with the tuner. The tuner at this point has automatically adjusted the tuning range to match

that pitch. To reset the tuner to standard 440Hz pitch you turn the tuner off and then back on again.

NOTE LED display:

These LEDs show the note being tuned. The LED under the note being tuned will be lit.

TUNE LED display

This series of 5 LEDs shows you if the note being played (tuned) is either sharp or flat.

To Tune:

1) Turn on tuner function

2) Play a note on your guitar. The tuner automatically senses the note being played and will show

you the note which is the closest to the one being played by lighting the appropriate LED in the

NOTE LED display.

CDEFGAB#