User Manual

Overload Relay Replacement

Disassembly

1 2

Ø1

Ø2

Ø3

3 4

T20

PN-11643

DIR 10000002827 (Version 01)

Printed in U.S.A.

Label or identify phase wires before cutting.

WARNING

To prevent electrical shock, disconnect from power source before installing or servicing.

WARNING

PAGE 1
Overload Relay Replacement WARNING To prevent electrical shock, disconnect from power source before installing or servicing. Disassembly 1 2 WARNING Label or identify phase wires before cutting. 1 2 2 1 3 1 3 4 S Ø1 Ø2 Ø3 x2 T20 PN-11643 DIR 10000002827 (Version 01) Printed in U.S.A.
PAGE 2
Reassembly 5 WARNING Be sure to run Phase 1, 2 and 3 through Phase 1, 2 and 3 of overload, respectively. Must use the wires that are not factory labeled. 6 WARNING Do not cross or mix-up phase wires while reconnecting. LABELED WIRES NOT STRUNG THROUGH OVERLOAD RELAY Ø1 Ø2 Ø3 S S LONGER WIRES NOT FACTORY LABELED S 20 lb-in x2 T20 7 WARNING Check for wire secureness after crimping. 8 x3 2 2 S S 1 .6 in (15mm) 1 x6 1 PN-11643 DIR 10000002827 (Version 01) Printed in U.S.A.