User Manual

Publication MP-IN011B-EN-P - April 2007

Installation Instructions

Size 36 Connector Kit for MPL-B9xx Motor Power

Catalog Number 2090-MPPC-X163

About This Publication

This publication provides wiring instructions for the Allen-Bradley Size 36 Connector Kit.

This connector kit provides an a 1½ NPT connection for conduit enclosing the power wire

run between the power connector on a MPL-B9xx motor and its input power source.

The MP-Series Installation Instructions, publication MP-IN002, details the motor interface.

Wire the Connector Kit

Refer to the illustration and the power connector pinout for your MPL-B9xx motor when

wiring this connector.

Tools you need to assemble the connector include a wire cutter, wire stripper, flatblade

screwdriver Ø 2.5 mm (0.10 in.) maximum, and solder iron.

Connector components are assembled in the order shown in the figure.

1. Thread each power wire through the connector backshell and lock ring.

ATTENTION

Do not use a petroleum based, or similar lubricant when inserting the pins into

the housing. This may effect the dielectric characteristics of the connector, and

the retention of the pins.

Alcohol or a lubricant that cleanly evaporates is recommended.

IMPORTANT

Always make effective electrical contact between the wire and pin connection.

360° shielding must be provided from the connector backshell to the drive.

PAGE 1
Installation Instructions Size 36 Connector Kit for MPL-B9xx Motor Power Catalog Number 2090-MPPC-X163 About This Publication This publication provides wiring instructions for the Allen-Bradley Size 36 Connector Kit. This connector kit provides an a 1½ NPT connection for conduit enclosing the power wire run between the power connector on a MPL-B9xx motor and its input power source. The MP-Series Installation Instructions, publication MP-IN002, details the motor interface.
PAGE 2
. Secure a contact pin on each wire lead. a. Strip the wire lead to 16.5 mm (0.65 in.). b. Fully insert the lead into the contact pin to the full depth of the pin. Less than 2.5 mm (0.1 in.) of wire should be visible between the contact pin and the wire insulation. c. Solder or crimp the lead to the contact pin. IMPORTANT If soldering the wire-to-pin connection, provide an adequate cooling period before inserting the pin. 3. Insert each connector pin in the appropriate location of the connector housing.