Installation Instructions Instruction Manual

Installation Instructions
871F Proximity Sensors
IMPORTANT: SAVE THESE INSTRUCTIONS FOR FUTURE USE.
871F for Hazardous Locations
Models to be covered:
Conduit 1/2 inch NPT
871F-P50BP80-T4
871F-P50BN80-T4
871F-N65BP80-T4
871F-N65BN80-T4
Conduit PG13.5
871F-P50BP80-Q4
871F-P50BN80-Q4
871F-N65BP80-Q4
871F-N65BN80-Q4
WARNING
Suitable for use in Class 1, Division 2,
Groups A, B, C, D or nonhazardous
locations only.
Explosion hazard: substitution of
components may impair suitability for
Class 1, Division 2.
Explosion hazard: Do not disconnect
equipment unless power has been
switched off or the area is known to be
nonhazardous.
General Specifications
Environmental
Certifications
cULus Listed and CE Marked for all
applicable directives
Enclosure Type Rating
NEMA 1, 2, 3, 4, 6, 6P, 12, and 13, IP67 (IEC
60529), 1200 psi (8270 kPa) washdown;
micro connector versions also meet IP69K
(IEC 60529)
Operating Temperature [C (F)] -25…+70° (-13…+158°)
Electrical
Load Current ≤200 mA
Load Current, Min. 1 mA
Leakage Current ≤10 μA
Operating Voltage 10…30V DC
Voltage Drop ≤ 2.5V
Repeatability ≤2%
Hysteresis ≤5% typical
Protection Type
False pulse, transient noise, reverse
polarity, short circuit, overload
Shock 30 g, 11 ms
Vibration 55 Hz, 1 mm amplitude, 3 planes
Optical
LEDs
Green: Power
Orange: Output Energized
Mechanical
Housing Material Valox®
Connection Types
Conduit Opening: 1/2-14 NPT thread,
PG13.5 thread