User Manual

19
Getting Connected and Installing Drivers
9. The screen will indicate “Click Restart to finish installing the software.”
Click [Restart] to restart your Macintosh.
* It may take some time for your Macintosh to restart.
This completes installation of the UM-1G driver.
Next, make MIDI device settings.
* You won’t be able to use the UM-1G unless you’ve made these settings.
1. Set the UM-1G’s [ADVANCED DRIVER] Switch to the ON position.
2. Connect the UM-1G to your Macintosh.
3. Open the Applications folder of your Macintosh hard disk. In the Utilities folder,
double-click [Audio MIDI Setup] to open the Audio MIDI Setup dialog box.
The Audio MIDI Setup dialog box will appear.
4. Click the MIDI Devices tab.
5. Confirm that UM-1G appears in the Audio MIDI Setup dialog box.
*If UM-1G does not appear or if it is grayed out, it means that the UM-1G
is not being recognized properly. Click [Rescan MIDI]. Also try
disconnecting and reconnecting the UM-1G.
* Previous settings from installation of a different version of the driver may
still remain. If this is the case, click on the grayed UM-1G to select it, then
click [Remove Device] to delete the settings.
MIDI Device Settings
Operation of the UM-1G
Operation of the UM-1G
4
7
6
Click MIDI Devices
Click Add Device
Click Show Info
UM-1G_e.book 19 ページ ２００８年１１月１１日 火曜日 午後６時３０分