User Manual

28
Troubleshooting
2. Choose Install the software automatically (Recommended) and click [Next].
3. If the Hardware Installation dialog box appears, click [Continue Anyway] to proceed
with the installation.
* If you are unable to continue, click [OK] to stop the installation, and refer to “Driver Signing
Options Settings (Windows XP)” (p. 27) and then reinstall the driver.
4. When the screen indicates Completing the Found New Hardware Wizard, click [Finish].
3. The screen will indicate “Installation complete.”
Click [Close] to close the Driver Setup dialog box.
4. If the System Settings Change dialog box appears, click [Yes]. Windows will restart.
If you were unable to complete the installation with the above procedure, uninstall the UM-
1G driver as described in “Deleting the Driver” (p. 34), and then reinstall the driver as
described in “Getting Connected and Installing Drivers” (p. 11).
Could you have connected the UM-1G to a different USB port?
Depending on your operating system, connecting the UM-1G to a different USB port may
cause a number to automatically be added at the beginning of the device name; this should
not be cause for concern when using the UM-1G.
If you want to return to the original device name, without a numeral, either connect the UM-
1G to the same USB port as you did when installing it, or uninstall the UM-1G driver as
described in “Deleting the Driver” (p. 34), and then reinstall it as described in “Getting
Connected and Installing Drivers” (p. 11).
A Numeral Such as “2- “ Has Started Appearing at the Beginning of the Device
Name
UM-1G_e.book 28 ページ ２００８年１１月１１日 火曜日 午後６時３０分