Operation Manual

12
Installing the Driver
A driver is software that transfers data between the A-PRO and the application software
on your computer when the A-PRO is connected to your computer.
Refer to the Roland website for the latest drivers and information about compatibility
with the latest operating system versions.
http://www.roland.com/support/
The procedure for installation and checking will depend on your system. Perform the
following two steps to install and check the driver.
fig.H_install.eps
Steps to be performed on the A-PRO keyboard itself are marked by a
symbol. Don’t connect the A-PRO to your computer until you
are told to do so.
* The example screen shots included here are taken from Windows 7.
1 With the A-PRO disconnected, start up Windows.
Disconnect all USB cables from your computer, with the exception of those for a
USB keyboard and USB mouse (if used).
Windows 8 users
Switch to the “Desktop.”
2 Close all currently running software.
3 Insert the included A-PRO CD-ROM into your CD-ROM drive.
4 In the [Driver] folder within the CD-ROM, double-click the [Setup]
icon to start up the installer.
Windows 8/Windows 7 users
Open “Control Panel,” click “System and Security,” and then click [System].
If the Control Panel shows the icon view, click [System].
1.
2.
Install driver
Windows 8 /
Windows 7 /
Windows Vista
P. 12
P. 19
P. 15
P. 19
P. 17
P. 20
Windows XP Mac OS X
Check
Windows 8/Windows 7/Windows Vista Users
Operation of the A-PRO
To open the Control Panel Windows 8 users
1. On the Start screen, click the Desktop.
2. Move the mouse pointer to the upper right or lower right corner of the
screen to display the charms.
* On touch-enabled PCs, swipe from the right side of the screen to display the
charms.
3. Click [Settings] and display the “Settings charms.”
4. In “Settings charms,” click [Control Panel] to open the “Control Panel.”
A-300_500_800C_e.book 12 ページ ２０１４年８月１９日 火曜日 午後３時２７分