Operation Manual

87
Controlling SONAR or SONAR LE from the A-PRO Series
The A-PRO series is compatible with SONAR or software in the SONAR LE series
(hereafter collectively referred to simply as “SONAR”).
After installing the A-PRO control surface plug-in, you’ll be able to use a keyboard from
the A-PRO series for controlling SONAR, using the ACT function.
SONAR X1 or later/SONAR LE
When you install SONAR X1 or SONAR X1 LE, the A-PRO control surface plug-in is
installed together with it.
SONAR 8.5 or earlier
1 Insert the supplied A-PRO CD-ROM into the CD drive.
2 Open the folder A-PRO_CSP on the A-PRO CD-ROM, then double-
click “Setup.exe.”
3 Follow the instructions presented by the installer to perform the
installation.
When the following two conditions are applicable, make sure that you select
“32-bit Version” in the “Choose version” dialog box.
• 64-bit OS installed
• SONAR LE or SONAR 32-bit version installed
1 Launch SONAR.
2 Access the control surface screen.
SONAR X1 or later/SONAR LE
From the SONAR menu, click [Edit] - [Preferences]; then from the menu at left, click
the control surface.
SONAR 8.5 or earlier
From SONAR’s menus, click [Options] - [Controllers/Surfaces].
3 Click [ ].
4 Make the following settings in the dialog box that appears, then
click [OK].
The [ACT] button on the A-PRO keyboard will light, and communication between
the A-PRO keyboard and SONAR will begin.
5 Close the dialog box.
Once you’ve made these settings, the A-PRO instrument and SONAR will
communicate with each other each time you open a project. Please be aware that
such communications can take a considerable amount of time; however, this
does not indicate a malfunction.
Installation Procedure
Making the Settings for SONAR
Parameter Setting
Controller/Surface A-PRO
Input Port A-PRO 2
Output Port A-PRO
A-300_500_800C_e.book 87 ページ ２０１４年８月１９日 火曜日 午後３時２７分